Menu
OPTIONS
NO TANG
SPECIFY NT
These Cylinders are available without the Tang section (covered by dimension “E”) at no extra charge. Suggested when Nose or Trunnion Mounting.
DOUBLE ROD PACKINGS
SPECIFY DRP
For all Type “AV” Cylinders, a second set of rod seals is available for Heavy-duty applications.
Note: Not available on 1-1/8″ bore size.
STAINLESS STEEL RETAINING RINGS
SPECIFY Q
Recommended for extremely damp or corrosive environments.
OPTIONS
(AVAILABLE AT EXTRA COST)

SPECIFY OR Non-locking Manual Over-Ride Levers are available on solenoid operated units. They are particularly useful for set-up or electrical failure.
SOLENOID OPERATORS
AAC – CONDUIT HOUSING, UL & CSA Listed.
AAD – DIN-type HOUSING with a male connector configuration of DIN 43650/ISO 4400.
Click here for female connectors.
AAG – GROMMET HOUSING, UL & CSA Listed.
AAS – SPLICE BOX HOUSING (STANDARD), UL & CSA Listed.
AAX – EXPLOSION PROOF, UL Listed covering Class I Groups C & D (NEMA 7)
and Class II Groups E, F & G (NEMA 9).
AAY – SPADE TERMINALS, UL & CSA Listed.
JIC – NEMA 4/IP-56
AAN6 – NEMA 6
SPECIAL VOLTAGES
A wide range of non-standard voltages are available. Specify voltage required.
PIPED EXHAUST ADAPTERS
SPECIFY PE Adapters are available which screw into the solenoid plunger housing, enabling
the solenoid exhaust to be piped from the actuator.
MATERIALS
Special seal compounds are available for a wide range of fluid media and environments. Tubes, Front Heads, Pistons and Rods can be supplied plated, hard coated or in other materials.
Please consult the factory for these special requirements, stating quantity required.
MODIFICATIONS
Listed below are some of the many modifications Allenair makes daily.
RODS: Non-Standard Rod Extensions (“H” Dim.) | SPECIFY Length Required |
FRONT HEAD: Non-Standard Cushion Adj. Screw Location & Extra Ports
Print from Customer required showing full details.
REAR HEAD: Non-Standard Cushion Adj. Screw Location & Extra Ports
Print from Customer required showing full details.
Non-Standard Swivel Hole (“Z” Dimension) in Tang: Size Required
Tang 90° from Standard: 90° Tang
SPECIAL DESIGNS Many times Allenair is able to change the standard configuration of our Cylinders to meet Customer’s special requirements. PLEASE CONSULT FACTORY ON THE ABOVE SPECIALS STATING QUANTITIES REQUIRED. |
ORDERING PROCEDURE![]() |
List all Cylinder and Valve Options alphabetically
CODES BC | DESIGNATION Cushions Both Ends |