Menu
ORDERING PROCEDURE & DIMENSIONS
ORDERING PROCEDURE
1) CYLINDER: When ordering Cylinders to be used with Adjustable Stroke Kits, specify “KR” after the Cylinder nomenclature to insure that the Cylinders will be supplied with the extra 2” threaded rod extension
(H & J dimensions) required for the installation of the rod tie bar.
2) KIT: Select type from table and advise stroke.
3) REAR MOUNT: Select from table.
DIMENSIONS
![]() |
![]() |
ADJUSTING INSTRUCTIONS
TYPE K:
This Kit has no V2 Valves, Actuating Arm KR-201 or Safety Screw KR207. Adjustment is made by positioning of Adjusting Lock Nuts A-1526 or A-226.
TYPE KRE, KRR & KRVCR:
Stroke adjustment on any automatic return side will depend strictly on the location of Actuating Arm KR-201. It is then recommended to set Adjusting Lock Nuts A-1526 or A-226 on that side after the required stroke has been obtained. This can be done by bringing the Adjusting Lock Nuts towards the Foot Mount until the automatic return feature stops functioning, then backing them off one full turn and locking them.
NOTE: KR-207 is a Safety Screw to prevent damage to the V2 Valve. In operation the maximum safe stroke, should be determined by the location of the Adjusting Lock Nuts. A-1526 or A-226 and the Actuating Arm should not come in contact with the Safety Screw.