You are now viewing:

Accessories


AB ACCESSORY PIN

The 1/16” throw of these pins can be used to actuate an electrical switch or small valve to control another piece of equipment. Actuation begins approximately 1/8” before full stroke of cylinder is completed, pins can be installed in one or both ends.

PIN LOCATIONS

Standard Cylinders:
Pins are located in the same plane as the tail pivot hole centerline and the ports are 180° from the pins.

Square Head Cylinders:
Pins are located 90° clockwise from ports, looking from rod end.

Valve-in-Head Cylinders:
Pins are located 90° counterclockwise from inlet port, looking from rod end. Special locations available upon request at additional cost.

ORDERING PROCEDURE

After cylinder nomenclature specify:
IF for pin installed in front end.
IR for rear end.
IB for both ends.

Available on All Types of 1-1/2”, 2”, 2-1/2”, 3” & 4” bore sizes.

Maximum operating pressure is 150 P.S.I.

*For rod end only, rear end is standard.
AB-90 SWITCH COUPLER

This aluminum coupler fits all the accessory pins and simplifies the mounting of a micro® type switch. A window in coupler provides for easy visual adjustment.

TIE-ROD KIT

The Tie-Rod kit gives our field proven cylinders additional strength for your most demanding applications. Available in all bore sizes up to 4″

Pneumatic Cylinders, Digital feedback air Cylinders, Air Cylinders, Small Bore Cylinders, Valve In Heads Cylinders, Cyl Check Cylinders, Air Clamp Cylinders, Small Bore SS Cylinders, Position Feedback Cylinders, Valves, 4 Way ¼, 3/8, & ½ NPT Valves, 2 Way, 3 Way Solenoid 1/8 & ¼ NPT Valves, 4 Way Direct Acting 1/8 NPT Valves, Time A Valve, Air Switch Valve, 1/8 NPT Poppet Valve